Tek1 Completes Detailing of JHC Canberra
Kudos to the engineers and architects on this project. Their support had been brilliant. We have never come across another engineer or architect who had been so prompt in resolving issues on this project. We were able to complete this project very quickly mainly because of the super support i n resolving RFIs from the […]
Can you spot the problem – #1
Attention detailers, Take a look at the following below and see if you can identify the issue/problem at hand. Take careful note of what I have marked up, and try to identify the issue. Here are the structural drawings: Answer: There is an unsupported hebel panel here. Without support, the panel will […]
advancesteel-Switch on tool palettes
I struggled a bit on finding the tool palette and switch it on and off. But once you know it is a no brainer. Here is a video on how to switch on and off the tool palette in advance steel
Maximum Frame sizes (Steel Detailing Tips)
Maximum Galvanizing size generally available in Australia 1400 WIDE X3100 DEEP X 12000 LENGTH Maximum width for road transport (laid flat on bed is 2500m) Please check out both the documents below. http://www.legislation.act.gov.au/di/2006-120/20060623-28031/pdf/2006-120.pdf https://www.tmr.qld.gov.au/Safety/Vehicle-standards-and-modifications/Loads-and-towing/Projecting-loads.aspx